Need Support? Let’s guide you to the right answer or agent.

OpenFlows Ideas Portal

ADD A NEW IDEA

All ideas

Showing 176

Add New Features through ModelBuilder to All Topologies

I know you can configure your [Active] topology data sets to cascade, but sometimes we inherit models that are not set up like this. When you do a bulk import, you have to then go and activate every feature set for every [Active] topology. Add a c...
3 months ago in Water Distribution Products / WaterGEMS 0 Future consideration

Post Calculation Processor Enhancements

Currently there is only one post calculation. It's a pain to keep reconfiguring the calculator. This could be a data store like most other things in GEMS where you can make a new one, edit them, pick which ones are active or which to run after a s...
3 months ago in Water Distribution Products / WaterGEMS 0 Future consideration

Selecting Upstream Catchments

We asking for a tool in SewerGEMS for directly select connected or upstream catchments to the element of for a specified outfall.
about 2 years ago in Storm and Sewer Products / SewerGEMS 2 Planned

web-based model viewer

In our sector of the company just me had the software watergems, so it would be awesome if we had a web-based model viewer just to share the results of the models, like pressure zones or headlosses. It would be an huge step for us, we also could u...
almost 2 years ago in Water Distribution Products / WaterCAD 0 Future consideration

Warning for Acute Angles Between Inlet and Outlet Pipes

Problem: The software does not warn users when the angle between the inlet and outlet pipes at a manhole is less than 90 degrees, which is a design flaw. Suggestion: Activate a warning when acute angles are detected between inlet and outlet pipes.
3 months ago in Storm and Sewer Products / SewerGEMS 0 Needs review

Automatic Manhole Numbering

Problem: Manhole numbering is done manually according to the layout of main lines and branches, which is time-consuming and error-prone. Suggestion: Add a feature for automatic numbering of manholes based on the network’s sequence.
3 months ago in Storm and Sewer Products / SewerGEMS 0 Needs review

Pipe Sizes and Slopes Based on Street Widths

Problem: Pipe diameters and slopes in rural area codes depend on the width of the streets and are currently input manually. Suggestion: Enable automatic selection of pipe diameters and slopes based on the street width in accordance with applicable...
3 months ago in Storm and Sewer Products / SewerGEMS 0 Needs review

Support for Preliminary Design Using Google Maps

Problem: In preliminary design stages, the absence of topographic surveys forces designers to rely on Google Maps for drawing site layouts manually and extracting elevations using separate tools. Suggestion: Integrate Google Maps as a background w...
3 months ago in Storm and Sewer Products / SewerGEMS 0 Needs review

[Copy] Allow the road slope to exceed the gutter cross slope

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...
6 months ago in Storm and Sewer Products 0 Needs review

Globally edit pipe material and associated properties

When globally editing pipe material in WaterCAD (using flextables -->pipe), the current option allows you to type in the name of the material, but the associated pipe properties are not updated. It would be convenient if you could globally edit...
3 months ago in Water Distribution Products / WaterCAD 0 Future consideration