When you create a profile, the default lines are thin and hard to see. If you make them thicker, it can look great. But you cannot save these changes as a default, AND (my favorite part) if you change the profile time step or play the profile the ...
Currently, if you select a different field for color-coding, the range mapping gets wiped out. If the field type is the same, should retain current mapping. For example, change Pressure (minimum) to Pressure or Pressure (maximum) and the color-cod...
Sometimes I want to do some field math off of custom fields. For example, I might want to know the difference between the maximum pressure and the minimum pressure for junctions. Currently I can add the fields and populate them but to populate the...
If I create controls for a VSP Battery element, close the controls dialog, then try to edit the controls by clicking the [...] in the VSP battery properties window, no controls will show up. The controls are visible in the full controls window. Se...
Currently, you can only select times one-by-one, which is difficult when you have a lot of times to look at. It's useful to see where on the curve the pump is operating for the entire model run rather than need to select specific times.
Sometimes you need to color code by a field that has long values or a lot of values. The color coding properties dialog lets you resize the columns in the table, but doesn't let you resize the window, making it difficult to work with.
Put the laterals and taps adjacent to each other in the element symbology TOC
I usually need to turn laterals and taps on or off at the same time, so it would be helpful to have them next to each other to make it easier to do without scrolling.
When you have a bunch of annotations and color coding for each element type, it becomes hard to differentiate the sections. It would be nice if there was an easier way to distinguish the element types from the annotations/color coding. If the elem...
0
Future consideration