Currently I use ORD and have to use Civilstorm license to run SCS hydrology. I don't really need the full hydrograph for all projects. It would be to have get peak discharge using the stormCAD license inside ORD.

Create a shape where the semi-circle is at the bottom of the channel in order to model a circular open channel section.

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

Even though grate input parameters such as grate length, grate width, and clogging factor already exist, the resulting grate area and perimeter used in both weir and orifice calculations are not reported as calculation outputs. The end user cannot...

If I create controls for a VSP Battery element, close the controls dialog, then try to edit the controls by clicking the [...] in the VSP battery properties window, no controls will show up. The controls are visible in the full controls window. Se...

Sometimes you need to color code by a field that has long values or a lot of values. The color coding properties dialog lets you resize the columns in the table, but doesn't let you resize the window, making it difficult to work with.

I usually need to turn laterals and taps on or off at the same time, so it would be helpful to have them next to each other to make it easier to do without scrolling.

When you have a bunch of annotations and color coding for each element type, it becomes hard to differentiate the sections. It would be nice if there was an easier way to distinguish the element types from the annotations/color coding. If the elem...

The Query Builder "unique values" often unhelpfully shows integer IDs instead of values.

When a model has a bunch of scenarios that you need to check, it would be helpful to have a "Batch validate" tool.